PDA

View Full Version : Kết nối dial-up qua cổng serial của router cisco



12-11-2004, 02:56 PM
Mong nhận được sự giúp đỡ gấp của các huynh !
Công ty mình có 1 router cisco 3660 có module NM-4T (4 port serial).
Các cổng 0 & 1 đã kết nối với X25, các cổng 2 & 3 shutdown. Nay mình muốn dùng các cổng 2 & 3 nối với modem để dial-up vào. Nhưng khi gắn modem vào và active các cổng 2 & 3 lên ( no shutdown) thì không được.
Khi sử dụng lệnh show interface serial1/2 thi được như sau :

Serial2/2 is down, line protocol is down
Hardware is M4T
Internet address is 10.10.10.10/24
MTU 1500 bytes, BW 64 Kbit, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation PPP, crc 16, loopback not set
Keepalive set (10 sec)
LCP Closed
Closed: CCP, CDPCP
Last input never, output 01:03:59, output hang never
Last clearing of "show interface" counters 02:29:45
Input queue: 0/75/0 (size/max/drops); Total output drops: 0
Queueing strategy: weighted fair
Output queue: 0/1000/64/0 (size/max total/threshold/drops)
Conversations 0/1/256 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
5 packets output, 70 bytes, 0 underruns
0 output errors, 0 collisions, 159 interface resets
0 output buffer failures, 0 output buffers swapped out
177 carrier transitions DCD=down DSR=up DTR=up RTS=up CTS=up

Có huynh nào biết thi giúp đỡ. Cảm ơn trước nha !

danguyennhi
12-11-2004, 03:11 PM
cấu hình interface serial 2/2 là không đủ. Phải cấu hình thêm phần line nữa.

trong trường hợp của anh, cái NM-4T đâu có hỗ trợ interface async đâu mà anh gắn modem?