? -- Present list of available commands
         arp -- Show arp table or arp-resolve an address
        boot -- Load and boot an executable image
         cat -- Concatenate (type) file(s)
 clear_ether -- clear ethernet port statistics
        copy -- Copy a file
       delay -- delay for <X> seconds
      delete -- Delete file(s)
         dir -- List files in directories
   dump_regs -- dump reset registers
       etest -- test emac driver code
  ether_init -- initialize ethernet port
  flash_init -- Initialize flash filesystem(s)
      format -- Format a filesystem
fs_erase_block -- erase flash block
     fs_show -- show flash file system
        fsck -- Check filesystem consistency
        gpio -- Read or write 1020 GPIO pin or dump GPIO registers
        help -- Present list of available commands
         iic -- 1020 I2C Bus Commands
    init_pci -- initialize pci bridge
    led_test -- cycle LED patterns
 load_helper -- Load and initialize a helper image
      memory -- Present memory heap utilization information
       mkdir -- Create dir(s)
        more -- Concatenate (display) file(s)
      rename -- Rename a file
       reset -- Reset the system
       rmdir -- Delete empty dir(s)
         set -- Set or display environment variables
    set_baud -- set baud rates
   set_sleep -- Pause (sleep) for a specified number of seconds
  show_ether -- show ethernet port statistics
    show_pci -- show pci setting
      switch -- report push button switch status
         tar -- extract or listing a tar file
   tftp_init -- Initialize tftp file system
        type -- Concatenate (type) file(s)
       unset -- Unset one or more environment variables
     version -- Display boot loader version
------------------------------

C2600 Boot Loader (AP3G2-BOOT-M) LoaderVersion 12.4(25e)JA1, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Compiled Wed 30-May-12 03:34 by binugopa