• If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Xin chào ! Nếu đây là lần đầu tiên bạn đến với diễn đàn, xin vui lòng danh ra một phút bấm vào đây để đăng kí và tham gia thảo luận cùng VnPro.

Announcement

Collapse
No announcement yet.

Lỗi CISCO Wireless WAP4410N bị treo

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Lỗi CISCO Wireless WAP4410N bị treo

    Chào mọi người, Nhờ mọi người giúp đỡ CISCO Wireless WAP4410N bị treo như sau Mình lắp 2 con CISCO Wireless WAP4410N Con thứ 1: Wireless Network Mode: B/G/N Mixed Wireless Network Chanel: 6 Security Mode: WPA2 Personel PID VID: WAP4410N-E V02 Software Version: 2.0.7.8
    Con thứ 2: cấu hình tương tự mình đã set sang Kênh 11
    Tình trạng hiện tại: Cứ khoảng 30 phút là bị treo, mình phải khởi động lại thì truy cập bình thường Đã updates Firmware mới nhất và reset cấu hình lại nhiều lần
    Xin cám ơn!


    Last edited by telnet; 23-03-2016, 02:32 PM.

  • #2
    có vài thứ em có thể thử:
    • Force the LAN port speed, ensure the router/switch match up
    • Use N or G only connection
    • Use TKIP security only (if you're using MAC product)
    • After firmware upgrade, factory default the unit and manually configure

    em xem thêm trường hợp tương tự ở đây:


    I maintain multiple buildings, and each building has anywhere between 1 and 4 Cisco/Linksys WAP4410N access points. The problem is that at random intervals, the access points just stop sending and receiving wireless traffic. Every day or two, I have to log into every single access point (either via ...


    Đặng Quang Minh, CCIEx2#11897 (Enterprise Infrastructure, Wireless), DEVNET, CCSI#31417

    Email : dangquangminh@vnpro.org
    https://www.facebook.com/groups/vietprofessional/

    Comment

    Working...
    X